ROAM R41 Replaces the CEL-FI GO MOBILE REPEATER
The CEL-FI ROAM R41 is a plug-and-play cellular coverage solution that provides reliable 3G, 4G, and 5G mobile voice and data coverage anywhere within the network. It is equipped with the 4th generation IntelliBoost chip, ensuring that no issues will be caused when on the move. The device is approved and operating across all Australian 3G/4G/5G frequency bands, including B1/2100, B3/1800, B5/850, B7/2600, B8/900, B26/850, and B28L/700L. It can be switched between Telstra and Optus (one carrier at a time). To switch between operators, you can download the CEL-FI WAVE app on iOS and Android devices
Power requirements being either 12 volt or 240 volt.
 
INSTALLATION
 
ROAM R41 is a state of the art, very complex “Smart Repeater” and is approved by Telstra if installed correctly.
It is guaranteed to provide massive signal enhancement in poor reception areas, however incorrect installation may significantly reduce performance.
Installation of a Cel-Fi  is best done by a qualified installer.
Vehicular Installation of the ROAM Cel-Fi  require you to take into account the vehicle’s safety mechanisms such as airbags, ABS, Traction Control, Stability Control and the auto electrics. Incorrect installation may result in water leaks, electrical failure, battery damage, fusing of internal wiring and cables or risk of FIRE. Misuse of this equipment could result in injury and equipment damage. In no event will Powertec Telecommunications P/L be responsible or liable for either indirect or consequential damage or injury that may result from the installation or use of this equipment.
If the above precautions are not fully understood, or if local conditions are not covered, contact your nearest Powertec Telecommunications sales or service representative for clarification.
You should also be familiar with applicable federal, state and local legislation and industry standards surrounding installations.